Manual Lathe HY3040 5 Axis CNC Wood Router Machine For Aluminum CNC Parts

Step 1. Preparation

(1)Below is our aluminum material before engraving:

(2)Below are our engraving bits:

(3)Below is the HY3040 5 axis cnc router machine used in our engraving process:

Step 2. Process：

These are our experimentalprocedures, which mainly include four aspects: rough engraving, AcurracyEngraving By 0.5mm R1 Ball Mill, Acurracy Engraving By 2.5mm flatbottom engraving bits and Acurracy Engraving By 1mm flat bottomengraving bits

（1）Rough Engraving

Table 1 .Rough EngravingParameter Table

（2）Acurracy Engraving By 0.5mm R1 Ball Mill

This is the first step ofAcurracy Engraving, which is mainly to polish aluminum parts.

Table 2 .HalfRough Engraving 0.5mm R1Ball Mill Parameter Table

（3）Acurracy Engraving By 2.5mm flat bottom engravingbits

This is the second step ofAcurracy Engraving, which is for the position that was not processed before.

Table 3. Acurracy EngravingBy 2.5mmflat bottom engraving bits Parameter Table

（4）Acurracy Engraving By 1mm flat bottom engravingbits

This is the final AcurracyEngraving, the precise production of aluminum parts is completed through thisstep

Table 4. Acurracy EngravingBy 1mm flatbottom engraving bits Parameter Table

Step 3. Product comparison before and afterengraving

Below,the left picture is theAluminum material before engraving, The right picture are the 3D picture fileand Aluminum parts after engraving

Chinacnczone wish youall the best.